I say *should* but, it was slightly convoluted. The IT guy couldn't quite access the ability, and the Help files were NOT a help.
So, I did what I do and posed the question to an Autodesk newsgroup.
Meanwhile, the IT guy physically takes the card from plotter and puts it into a desktop HP printer owned by our receptionist, and uses that to program in the number. He puts it back into the plotter and we're good to go.
After he'd worked around it, I went back and checked for some answers.
Matt Stachoni went and tried his out again and came back with these steps:
Basically, it goes like this:Go to Top Menu > Setup Menu > I/O setup > Card Setup > ConfigurationWhen you get to CFG NETWORK=NO* hit, then the UP arrow to YES and hit to accept this. This modifies the menu system to allow access to the card settings. Now, hit the UP arrow (^) to start configuring the network parameters. Keep hitting the ^ arrow to access the next setting. Hit enter to change a setting, then use the UP arrow to set the setting,to accept, then UP to the next setting. I use the following settings (* denotes the default setting on my plotter)TCP/IP=ON*
IPX/SPX=OFF*
ATALK=OFF*
DLC/LLC=OFF*
CFG TCP/IP=NO* : Hit UP arrow to YES,to accept, UP arrow to next...
BOOTP=NO*
DHCP=NO*
AUTOIP=NO*
IP BYTE 1 - 4 =
SM BYTE 1-4 is your Subnet Mask, which should be 255.255.255.0
GW BYTE 1-4 is your Internet Gateway address
LG BYTE 1-4 is something I don't know, I used 0.0.0.0Everything else was by default (I didn't configure DNS).Hope it helped.
So, thanks to Matt for taking the time to document that for me, I'm putting it here to share with others (with Matt's permission), as I think it is a valuable little piece of information that could save others some frustrations.
Happy plotting.
0 comments:
Post a Comment